| Amplitude specifications |
- Number of output channels - 1
- Output impedance - 50 ± 2,5Ohm
- Channel output ranges:
±3 V(±1,5 V) on 1 KOhm load (50 Ohm)
±8 V(±4 V) on 1 KOhm load (50 Ohm)
- DAC resolution: 14-bit
- Voltage resolution, not worse than: range
±3 V- 0,4 mV range
±8 V- 1 mV
- ADC:
Input range ±10 V
Resolution - 14 bit
|
| Time and frequency specifications |
- Sampling rate: 0.25 Hz – 100 MHz.
- Rise/fall time, not worse than: 10ns
- 2 built-in analogue low-pass filters: Batterwart and Bessel
with 50 MHz cutoff frequency.
- Frequency ranges:
Sine and Triangle waves 0.1 Hz – 10 MHz,
Square waves 0.1 Hz – 50 MHz.
- Relative accuracy of frequency installation for the sine,
triangular and rectangular form - ±0,002 % from all frequency
range
- Memory depth - 64KS
|
| Triggering |
- Generator provides the following trigger modes:
internal – user or program start – transient (one shot)
or repetitive (while not stopped)
external– from rise/fall edge of external pulse with TTL-compatible
levels – transient (one shot per pulse) or repetitive (while
not stopped by user or program)
- External trigger time uncertainty is not more than: 10
ns
- Discretization of front edge installation of output sync
signal - 50 ps
|
| Other |
- Interface - PCI bus, 33 MHz, 32-bit.
- Consumption - 7 W
- Size - 192x94x20 mm
- Weigth - 0,2 kg
|
| Basic program-functional caracteristics of B-230 |
- Software fo Microsoft Windows 98/NT/2k/XP
- Self-calibration and setup of generated a signal amplitude
depending on load
- The standard waveforms are:
DC
Sine
Triangle (including Ramp)
Square
Exponent
Noise
- Generator software provides signal creation in the following
ways:
by choosing from the set of standard signals (see below)
and specifying its basic parameters
by entering analytic expression with using functions library
by graphic input, for example, mouse drawing
by import from text (ASCII) files, which have information
about stored signals, including those that were measured
with digital oscilloscope or were described in the other
software
by any combination of ways described above
- Possibility for output signals to change its basic parameters
“on the fly” (amplitude, offset, frequency, etc).
Download the software
and the documentation
|
